Euphonix System 5 User Manual

System 5 Digital Audio Mixing System Operation Manual Dynamic Automation
199
14.8.2 Fill Start
1. Press the Fill Start key in the center section automation panel.
The Fill Start key flashes.
2. Punch in the parameter and adjust the control to the desired level.
3. Punch out and the level at that time is written to the start of the mix.
The Fill Start key stops flashing indicating it is no longer active.
Fill Start is useful for writing mutes to the beginning of a song.
1. Locate to the Title start.
2. Set all Fader On switches to Write Absolute mode for channels that should not
be active at the song start.
3. Punch in, mute the On switch and punch out just before the song actually starts.
This mutes the channel back to the Title start.
14.8.3 Fill End
1. Press the Fill End key in the center section automation panel.
The Fill End key flashes.
2. Punch in the parameter and adjust the control to the desired level.
3. Punch out and the level at that time is written to the end of the mix.
The Fill End key stops flashing indicating it is no longer active.
Fill End is useful to quickly fill a static value to the end of a mix without recording to
the end.
NOTE: Pressing Fill Start or Fill End twice in rapid succession will cause the key to
latch on so it remains active after the pass ends.
Fill
Fill

Euphonix System 5 Specifications

General

Brand	Euphonix
Model	System 5
Category	Music Mixer
Language	English