System 5 Digital Audio Mixing System Operation Manual Quickstart to Common Tasks
31
Route to the Mix Bus
1. Plug a microphone into Channel 1 of the ML530.
2. To listen to the mic return, press the Mix button on channel 3 and select the
On key of the B Mix bus.
3. In the Master Section, press the CR Source key to display the Mix Busses in
the Panel Viewer and select the B Source.
4. Move channel 3’s fader up and set Pan to center.
5. In the Master Section, press the CR Output key to display the output formats
in the Panel Viewer and select Stereo.
6. Turn off the Cut button and use the Main Monitor knob in the Master Section
to adjust the control room monitor level.
To Next Page
Loading...
