FoxGate S6424-S2C2 series User Manual

Monitor Link Configuration
251
# Enable MMU packet sending
Device-C(config)#mac-address-table move update transmit
#Show Flex Links
Device-C(config)#show interface switchport backup
ActiveInterface BackupInterface State
----------------------------------------------------------
e1/0/1 e1/0/2 active up /backup Standby
Preemption mode: Forced
Preemption Delay: 5 seconds
Total record 1.
Device-C(config)#show mac-address-table move update
Dst mac-address: : 01:80:c2:00:00:10
Default/Current settings: : Rcv Off/Off,Xmt Off/On
Rcv Count: : 0
Xmt Count: : 0
Device A
# Configure GE1/0/1 and GE1/0/2 to be Trunk and enable MMU packet receiving
Device-A(config)#interface range ethernet 1/0/1 ethernet 1/0/2
Device-A(config-if-range)#switchport mode trunk
Device-A(config-if-range)#exit
Device-A(config)#mac-address-table move update receive
Device B
# Configure GE1/0/1 and GE1/0/2 to be Trunk and enable MMU packet receiving
Device-B(config)#interface range ethernet 1/0/1 ethernet 1/0/2
Device-B(config-if-range)#switchport mode trunk
Device-B(config-if-range)#exit
Device-B(config)#mac-address-table move update receive
# Configure GE1/0/1 to be uplink port of Monitor Link group 1，GE1/0/2 to be downlink
port of Monitor Link group 1
Device-B(config)#interface ethernet 1/0/1

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English