FoxGate S6424-S2C2 series User Manual

Monitor Link Configuration
252
Device-B(config-if-ethernet-1/0/1)#switchport monitor-link-group 1 uplink
Device-B(config-if-ethernet-1/0/1)#exit
Device-B(config)#interface ethernet 1/0/2
Device-B(config-if-ethernet-1/0/2)#switchport monitor-link-group 1 downlink
Device-B(config-if-ethernet-1/0/2)#exit
#Show Monitor Link
Device-C(config)#show monitor-link-group
Monitor-link Group
--------------------------------------------------
Group 1:
UplinkID UplinkStatus
e1/0/1 UP
DownlinkID DownlinkStatus
e1/0/2 UP
Device D
#Configure GE1/0/1 and GE1/0/2 to be Trunk and enable MMU packet receiving
Device-D(config)#interface range ethernet 1/0/1 ethernet 1/0/2
Device-D(config-if-range)#switchport mode trunk
Device-D(config-if-range)#exit
Device-D(config)#mac-address-table move update receive
# Configure GE1/0/1 to be uplink port of Monitor Link group 1，GE1/0/2 to be downlink
port of Monitor Link group 1
Device-DB(config)#interface ethernet 1/0/1
Device-D(config-if-ethernet-1/0/1)#switchport monitor-link-group 1 uplink
Device-D(config-if-ethernet-1/0/1)#exit
Device-D(config)#interface ethernet 1/0/2
Device-D(config-if-ethernet-1/0/2)#switchport monitor-link-group 1 downlink
Device-D(config-if-ethernet-1/0/2)#exit
#Show Monitor Link
Device-D(config)#show monitor-link-group
Monitor-link Group
--------------------------------------------------

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English