Executing Calibration
119
Maintenance
3
3
Set [Screen Type], [Paper Supply], and [Target].
z
The following describes calibration procedures using Copy Job 2, as an example.
z
For [Paper Supply], select the paper tray in which A4 , A3 , 8.5 x 11" , or 11 x 17" white paper is
loaded.
z
For Target, select from [Copy & Print Jobs], [Copy Jobs Only], [Print Jobs Only], and [None]. When [Copy &
Print] is not selected for [Target], calibration is not valid for the mode not listed in [Target].
4
Select [Start].
z
The message "Outputting the Calibration Chart... - Copy Job 2" appears and the document for calibration
(Calibration Chart) is printed.
5
Align the magenta patch (squares printed at the top and bottom of the Calibration Chart)
of the printed Calibration Chart against the left side of the document glass, and load the
chart facing down on the document glass.
z
Place the Calibration Chart on the document glass.
To Next Page
Loading...
Need help?
General
