Setup
333
Tools
5
User Name
Set the user name when a user name is required to be input by the forwarding destination
server.
When [FTP] is selected for [Transfer Protocol], up to 97 characters are allowed.
When [SMB] is selected for [Transfer Protocol], use one of the following formats:
îš‹
For UPN Format:
User name@Domain name (User name: up to 32 characters / Domain name: up to 64
characters)
For example: fuji@example.com ("fuji" is a user name and "example.com" is a domain
name)
îš‹
For NetBIOS Format:
Domain name\User name (Domain name: up to 64 characters / User name: up to
32characters)
For example: example\fuji ("example" is a domain name and "fuji" is a user name)
îš‹
For workgroups:
Local user (up to 32 characters)
For example: Fuji-Taro
Password
Set a password when the forwarding destination server prompts a password entry. You can
enter up to 32 single-byte characters for a password.
Port Number
Set the forwarding destination port number. Specify a number from 1 to 65535.
Fax Number
Enter a fax number with up to 128 digits.
z
For information about how to enter characters, refer to "Entering Text" (P.46).
Index
You can register a single alphanumeric index character for use as a keyword to search with
the Address Book.
z
For information about how to enter characters, refer to "Entering Text" (P.46).
Starting Rate
Set a communications mode. You can select from [G3 Auto], [Forced 4800bps], and [G4
Auto].
When the destination is specified by a speed dial number with the communications mode
set, you cannot change the communications mode in the [Fax/Internet Fax] screen.
z
[G4 Auto] is displayed only when Internet fax addresses are selected.
To Next Page
Loading...
Need help?
General
