Error Code
511
Problem Solving
15
116-710
[Cause] A probable cause is that the correct document size could
not be judged as the receive data exceeded the HP-GL/2
spool size.
[Remedy] Increase the size assigned to HP-GL/2 auto-layout
memory.
116-713
[Cause] Job was divided and printed due to insufficient disk
space.
[Remedy] Remove unnecessary data from the hard disk to
increase free disk space.
116-714
[Cause] An HP-GL/2 command error occurred.
[Remedy] Check the print data.
116-720
[Cause] An error occurred during printing as there was
insufficient memory.
[Remedy] Stop unnecessary ports, remove unnecessary data from
the hard disk to increase free disk space.
116-740
[Cause] Numerical value operation error occurred as a value
exceeding the value limit of the printer was used in the
print data.
[Remedy] Check the print data.
116-747
[Cause] There are too many paper margin values for the HP-GL/
2 effective coordinate area.
[Remedy] Reduce the paper margin values, and instruct it to print
again.
116-748
[Cause] There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
116-749
[Cause] Job cancelled because the specified font was
unavailable.
[Remedy] Install the font, or setup font replacement on the print
driver side.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
116-790
[Cause] There was a problem with parameters in the JBIG data.
They were automatically edited.
[Remedy] If any problem occurs in job result, try to process the job
again.
116-780
[Cause] There is a problem with the document attached to the
received e-mail.
[Remedy] Check the attached document.
123-400
[Cause] A malfunction occurred in the machine.
[Remedy] Power-cycle the machine. If the machine is not improved
by performing the relevant remedy, Contact our
Customer Support Center.
Error Code
Category
Cause and Remedy
CPSMO
To Next Page
Loading...
Need help?
General
