4.8 Configuring the Network Settings
122
■ Setting the Link Speed/Duplex Mode
While the network operating status is correct, if the network is not communicating
properly, change the Link Speed/Duplex Mode settings.
1. On the [Network Status] window, change [Link speed/Duplex mode] to a
fixed mode.
2. Press the [OK] button.
D The Link Speed/Duplex Mode setting is changed.
■ Setting Wake On LAN
Set whether or not to enable Wake On LAN to turn the scanner on/off via the network
interface.
1. For [Wake On LAN] on the [Network Status] window, select whether to
enable Wake On LAN.
2. Press the [OK] button.
D Wake On LAN is set.
z If connection to LDAP server is not possible, try the following steps:
1. Disconnect the LAN cable.
2. Press the [Shutdown] button on the LCD touch panel to turn the scanner
off.
3. Press the power button to start the scanner with the LAN cable
disconnected.
4. Enter a non-duplicated IP address.
5. Re-connect the LAN cable to the scanner.
z If the DHCP server cannot be reached when DHCP is set to [On], the IP
address is set to "169.254.XXX.YYY" (where XXX and YYY are arbitrary
values between 0 and 255).
To Next Page
Loading...
