411
6.14.3 Checking the Number of Sheets to Be Scanned
When a job is processed, the expected number of sheets to be scanned can be specified,
so that the actual number of scanned sheets can be checked after a scan.
1. On the [Job Menu] window, press the [Job] button.
2. On the [Scan Count] window, enter the number of sheets that are to be
scanned, between 1 and 999.
For either of the following settings, the [Scan Count] window is not shown.
z The [Scan Count] is not to be checked
z The [Scan Count] is to be checked, but the [Scan Count] window is set not to
appear (The [Allow per-Job adjustment] check box in the [Check the Scan Count]
on the [Job Details] window is disabled)
z When [Print] is included in the job sequence, the number of sheets to be
scanned can be set within the range of 1 to 100, but not 1 to 999.
z For [Print], up to 100 pages can be scanned. For other than [Print], up to 999
pages can be scanned. Therefore, for duplex scanning, make sure to set the
number of pages so as not to exceed these respective maximums.
To Next Page
Loading...
