Fujitsu ScanSnap N1800

189
4.16.3 Maintaining Add-in Modules
An "Add-in" is an application created by using the ScanSnap N1800 SDK (development
kit).
This section describes how to check the Add-in status, how to install/uninstall an Add-in
module, how to upload an Add-in settings file, and how to set the on-screen keyboard to
be displayed when running an Add-in.
■ Installing an Add-in Module
Up to six Add-in modules can be installed.
1. Select [Monitoring & Management] J [Maintenance] J [Add-in Software].
D The [Add-in Software] window appears.
2. Press the [Browse] button to specify an Add-in installation file.
3. Press the [Install] button.
D The Add-in module is installed, and the Add-in name is displayed in the list.