6.14 Processing a Job
410
6.14.2 Changing a File Name (for Save/e-Mail Attachment)
When a job is processed, file names to be used when saving or attaching scanned data to
an e-mail can be changed.
1. On the [Job Menu] window, press the [Job] button.
2. On the [File Name] window, enter the file name for the scanned data to
be saved or sent by e-mail.
It is not possible to change a file name when the [File Name] window is set not to be
shown.
z When sequence numbers are set to be appended to file names, a sequence
number is appended to the end of the default file name. The guidance
message "A sequence number will be appended to the file name." is shown
on the window.
z A sequence number will not be appended to a file name that has been edited.
z After entering the file name, press the [Scan] button to start the scan. If any
further job setup steps are required, press the [OK] button that appears
instead.
To Next Page
Loading...
