Fujitsu ScanSnap N1800

6.4 Sending the Scanned Data by e-Mail
320
z For distribution lists
On the [Distribution List] tab, enter the list name and e-mail addresses to be added
to the distribution list.
For details about e-mail address settings values, refer to
"B.1 e-Mail Address
Setting Values" (page 483)
.
6. Press the [OK] button.
D The e-mail addresses and distribution lists are added to your My List.
e-Mail addresses can be selected from the e-mail address book, which can be
accessed by pressing . For details, refer to
"6.4.1 Selecting an e-Mail
Target from the e-Mail Address Book" (page 313)
.
If the e-mail address book cannot be used, contact the administrator.
My List can also be edited using User Editor.
For details, refer to
"Appendix E Editing Using User Editor" (page 496).