Fujitsu ScanSnap N1800 User Manual

447
When checking the network connection status by a Ping test, the following results are
possible.
Follow each action described below.
■ Details
Network connection is working properly.
■ Details
There is no response from the Ping target.
■ Action
z The specified Ping target might not be correct. Check that the Ping target IP address, host
name or FQDN is correct.
z The network transmission mode may differ from the connection target. In
"4.8.7 Checking the
Network Operating Status" (page 121), change [Link Speed/Duplex Mode] from "Auto-
Negotiation" to a fixed mode.
z If the Ping target is correct and the network transmission method is appropriate, refer to
"Failure to Connect to a Server Using Its IP Address" (page 451) for further solutions.
■ Details
Communication with the Ping target is not stable.
■ Action
z There may be a quality problem with the LAN cable. Replace the LAN cable and try again.
z The network transmission mode may differ from the connection target. In
"4.8.7 Checking the
Network Operating Status" (page 121), change the [Link Speed/Duplex Mode] from "Auto-
Negotiation" to a fixed mode.
■ Details
A hardware problem might have caused a communication channel error. For example, the LAN
cable may have become disconnected during the Ping test.
■ Action
Check the status of the LAN cable and try again.
"Ping statistics" shows "Lost=0 (0% loss)".
"Ping statistics" shows "Lost=4 (100% loss)".
"Ping statistics" shows "Lost=N (1 to 99% loss)".
Hardware error.

Fujitsu ScanSnap N1800 Specifications

General

Film scanning	No
Color scanning	Yes
Input color depth	- bit
Maximum scan size	216 x 356 mm
Output color depth	24 bit
ADF scan speed (color, A4)	20 ppm
Optical scanning resolution	600 x 600 DPI
Duplex ADF scan speed (color, A4)	20 ipm
Display	TFT
Scanner type	ADF scanner
Product color	Black, Grey
Display diagonal	8.4 \
Display resolution	1024 x 768 pixels
Scan to	E-mail, Fax, File, FTP, Image
Sensor type	CCD
Scan file formats	JPG, PDF, TIFF
Maximum duty cycle	12000 pages per month
Daily duty cycle (max)	2000 pages
Minimum scan area (ADF)	50.8 x 50.8 mm
ISO A-series sizes (A0...A9)	A4, A5, A6, A7, A8
Maximum ISO A-series paper size	A4
Auto Document Feeder (ADF) media weight	52 - 127 g/m²
Auto document feeder (ADF) input capacity	50 sheets
Safety	LDAP, LDAPS, FTPS, HTTPS
Cabling technology	10BASE-T, 100BASE-TX
Networking features	Fast Ethernet
Supported network protocols	TCP/IP, DHCP, SMTP, SMB, LDAP, NTP, FTP, HTTP
Input voltage	100-240 V
Power supply type	AC
Power consumption (off)	0.5 W
Power consumption (standby)	15 W
Power consumption (typical)	50 W
Sustainability certificates	ENERGY STAR
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	RoHS

Weight and Dimensions

Depth	226 mm
Width	300 mm
Height	172 mm
Weight	6000 g