To Next Page

To Previous Page

General Procedures

Procedure

1. Enter UI Diagnostic mode (see Entering and Exiting Maintenance/Diagnostic

Tools Mode).

2. Select the "Machine Status" button on the UI Control Panel (the right side hard

button immediately below the touch display).

3. Select the "Tools" tab.

4. Scroll to the bottom of the "Features" group.

5. Select the "Maintenance/Diagnostics" button on the UI screen.

6. Select the "IO Check" button.

7. Enter Chain-Link values as directed in the Component Control Tables, Section

6.3 and 6.4

8. From the IO Check menu, select Component Control. The following are

displayed:

• Chain - Link dialog boxes (Refer to the appropriate table for the Chain-Link

code number)

• Table 1 GBC Inputs

• Table 2 GBC Outputs

• Enter Number button

• Show Current Status button

• Cyclic Motion check box

• Input / Output dialog box

• Counter dialog box

• Status dialog box

9. Enter the 6-digit chain-link (code) number for the component.

10. Press the Start button on the UI to energize the output component or to read

the status of the input component.

11. Select Cyclic Motion for the component to repeat the operation.

12. Input/Output column (component type), Status column (Operation status), and

Counter column (Operation Count) are displayed on the Component Control

screen.

13. Press the Stop button on the UI to halt the component operation.

Select Close to exit from Component Control.

6.1.3 NVM Read/Write

Purpose

The purpose of this section is to provide a method to check and adjust certain

machine parameters stored and adjusted electronically. Adjustments to values are

retained after exiting this mode.

Procedure

1. Enter UI Diagnostics Mode (see Entering and Exiting Maintenance/Diagnostic

GBC AdvancedPunch User Manual

Questions and Answers: