Repair and Adjustment Procedures
Advanced Punch Service Manual © Copyright 2009 GBC. All rights reserved. 4-65
4.9.5.1 Punch Module Motor Drive Belt Replacement
Procedure
Replace the belt when it is frayed, missing teeth, or worn out.
To replace the Punch Module drive belts:
1. With the fan removed from the shaft, work the belt [1] off the clutch gear [2].
Figure 4.74 Motor Pulley and Belt.
2. Install a new belt by looping it over the motor pulley and then work it onto the
clutch gear.
The belt requires no adjustment. It should have slight deflection when pressed.
To Next Page
Loading...
