GBC AdvancedPunch - Aligner Panel Inspection and Cleaning

Maintenance
Advanced Punch Service Manual © Copyright 2009 GBC. All rights reserved. 1-15
1.4.10 Aligner Panel Inspection and Cleaning
Maintenance Schedule
Clean every 750K cycles.
Procedure
Inspect for worn or damaged parts. Clean with alcohol, an approved cleaner, or a
soft cloth moistened with mild detergent and warm water as needed.
To clean the Aligner Panels:
1. Lift the Aligner latches to open panels.
2. Clean surfaces [1].
3. Clean paper alignment channels [2].
Figure 1.11 Aligner Panel Components.
[1]
[2]