Installation and Set Up
Advanced Punch Service Manual © Copyright 2009 GBC. All rights reserved. 8-11
8.3 Unpacking
• Inspect the outside of the package for shipping damage. If there is evidence of
shipping damage, contact the shipping carrier immediately.
• Remove the punch from its shipping carton.
• Inspect for any concealed damage to unit. If there is evidence of concealed
shipping damage, contact the shipping carrier immediately.
• Remove all shipping tape from doors and levers.
8.4 Test Operation
• Check to ensure that the paper chip tray is securely in place.
• Check to ensure that a Die Set is installed properly and that any extra Die
Sets are securely stored in the Die Storage Area.
• Run a small test job in Bypass mode. Check to ensure that the job is not
punched and bypasses properly.
• Run a small job with Punch Enabled. Check the punched holes of the job.
• Ensure the paper output is stacking properly.
• Ensure the hole quality of the sheet output is proper
To Next Page
Loading...
