General Procedures
Advanced Punch Service Manual © Copyright 2009 GBC. All rights reserved. 6-9
6.7 Tools
Tools recommended for service of the GBC Advanced Punch:
Standard Measure Tools (English as opposed to metric)
• Open end ignition wrench - 1/4" (required only for chad kit installation)
• Phillips screwdriver or 1/4” (6.5 mm), 5/16" (8 mm) and 11/32" (9 mm) nut drivers
• Hex wrenches, 3/32", 5/64", 9/64" and 0.050"
Other Recommended Tools and Supplies
• Needle nose pliers
• Wire cutters
• Screw driver, flat head, small
• Supply of wire tie wraps
• Snap Ring pliers
GBC Supplied Tool Kit Part Number
• 600N03329 - TOOL KIT W/WRENCH
6.8 Lubrication
For General lubrication please see the following sections
• Dieset pins- 1.3.4
• Dieset shoulder bolts- 1.3.4
• Punch Drive cam- 4.9.2
To Next Page
