GE Datex-Ohmeda S/5 Series - Compact Airway Module, E-CXXXXX; M-CXXXXX; Display; Display Unit; Frame Unit

13
Document no. M1144953-001
2.2.2 Display
1. Check that the picture on the screen is adjusted correctly..
"
2.2.3 Keyboard(s)
1. Tests with the Command Board:
− Press the
Help key. Turn the ComWheel in both directions and check that the cursor
in the menu moves correspondingly. Select Normal Screen and check that the
menu disappears from the screen.
Check the rest of the menu keys by pressing them one by one.
Tests with the ARK Keyboard:
− Enter the Keyboard service menu
− Check the function of the ComWheel.
− Press all keys, except
Modify and Print. Check that each key produces a sound
from the loudspeaker, or the ‘Message count’ value in the service menu increases.
− Press the
Modify and Print keys and check that the corresponding menus appear
on the monitor screen.
Tests with the Remote Controller:
− Enter the Keyboard service menu.
− Check the function of the Comwheel.
− Press all keys. Check that each key produces a sound from the loudspeaker, or the
Message count value in the service menu increases.
2.2.4 Display Unit
1. Check that the clock on the screen shows correct time.
Readjust the time and date, if necessary.
2. Enter the Service Log service menu.
Check the content of the Service Log for possible problems.
"
2.2.5 Frame Unit
1. Check that the Frame unit fan is running.
"
2.2.6 Compact Airway Module, E-CXXXXX/ M-CXXXXX
1. Check that the fan is running.
2. If the module contains membrane keys on the front panel, press each of the keys for at
least one second and check that they are identified.
NOTE: The Compact Airway Module membrane keys require S/5 main software.
3. Wait until the message ‘Calibrating gas sensor’ disappears from the screen, then enter
the Compact Airway Module Ge n e r a l service menu.