GE Datex-Ohmeda S/5 Series - Figure 15 an Example of Interfacing External Devices with Device Interfacing Solution; Selecting the External Device

Interfacing
41
Document no. M1144951-004
Figure 15 An example of interfacing external devices with Device Interfacing
Solution
(1) Datex-Ohmeda S/5 Compact Anesthesia Monitor (with software L-CANE02(A) or later)
(2) Aestiva/5 anesthesia machine
(3) RGM monitor
(4) Interfacing module
NOTE: You can connect up to ten (10) interfacing modules to one system simultaneously.
Check the maximum number of modules: one meter cable = max. four ten modules, three
meter cable = max. three modules, six meter cable = one module.
CAUTION Make sure that the interfacing module is always used in vertical position to
prevent water from entering the module.
CAUTION Make sure that you are connecting the interfacing module to the device
specified in the label.
4.2.4 Selecting the external device
1. Turn off the monitor.
2. Turn off the external device.
3. Connect the interfacing module to the monitor’s connector for N-DIS or to another
interfacing module.
4. Connect the device specific cable to the external device and turn the external device on.
5. Turn the monitor on. The monitor identifies the connected device automatically.
1
4