GE Datex-Ohmeda S/5 Series - Table 11 bis Engine and DSC Error Messages

Service Menu
65
Document no. M1144955-001
Table 11 BIS Engine and DSC error messages
Message Errors of type 2
Illegal message ID Errors for layer 3 packets
Illegal command parameter
Illegal length for layer 2 data
Disabled interrupt received -
UART transmitter empty interrupt
UART related errors
Disabled interrupt received -
UART modem interrupt
No status nibble received DSC related errors
DSC not connected
DSC disconnected after test failure
Illegal DSC ID
DSC power regulation fault
DSC interface fault
DSC did not respond to command
Illegal PIC ID
DSC overcurrent
DSC overrun
EEPROM Bad packet length Software update related
errors
EEPROM Bad checksum
EEPROM Bad code length
EEPROM Illegal packet subtype
EEPROM physical write error
EEPROM NOT_DATA_TIMEOUT