GE Datex-Ohmeda S/5 Series - To Disassemble the Display Unit of F-CM(C)(REC)1 Rev.00

Display Unit for F-CM(C)1 (Rev. 05), F-CM(C)REC1 (Rev. 01)
35
Document no. M1144956-003
3.3.2 To disassemble the Display Unit of F-CM(C)(REC)1 rev.00...03
1. Set the Compact Monitor lying on its rear side.
2. Turn the quick lock screw at the bottom of the Display Unit counter clockwise to release it.
3. Pull the Display Unit carefully upwards and detach the Network and NetID cables.
4. Set the Display Unit lying on its front side; be careful not to damage the ComWheel or the
LCD screen.
5. Open and detach the four screws with the washers at the corners of the Display Unit.
6. Lift the Display Unit carefully from the side of the unit (Note that the Front Unit is
connected with short flat cables to the Central Processing Board). Detach the two flat
cables from the CPB X7 and X5 connectors. Please note that the connectors are fragile; do
not bend them while disconnecting the cables.
7. Lay the Display Unit carefully on the table.