Document no. M1144955-001
1.3.2 Communication
Interface status indicates the status of the data link
between the CPU and MEM sections. If the MemCard
option is installed, the status should always be on
ACTIVE. If the status blinks between ACTIVE and
CLOSED, a communications error has occurred.
Message types indicates the type of data packets
that have been sent (Tx) and received (Rx) since last
monitor start. Data types are listed on the lines below
Message types text.
Data types:
Record K indicates the communication
between the Monitor and Record
Keeper.
File Operation indicates the operations of Patient data.
Service indicates the MEM section operations.
Modes indicates the User Mode operations.
Module status indicates the number of sent/received data packets that relate to the MEM section status.
Packets total indicates the total amount of data packets that have been sent/received since the last
monitor start.
Bytes total indicates the total amount of data bytes that have been sent/received since the last monitor
start.
The last four lines indicate transmission errors:
Timeouts indicates the number of timeouts that have occurred in MEM section data transmission since
the last monitor start.
Chksum err indicates the number of checksum errors in data packets from MEM section since the last
monitor start.
Length err indicates the number of data packets with erroneous length from the MEM section since the
last monitor start.
Duplicated indicates the number of duplicate data packets from the MEM section since the last monitor
start.
To Next Page
Loading...
