Interfacing
49
Document no. M1144951-004
4. Connect a common RS-232 modem cable’s (order code 78031) DB9 connector to the
serial port connector X4 on the monitor, and the DB25 connector to the converter.
5. Connect the converter to external power supply using the power adapter PS1002-xx.
Figure 17 Connecting S/5 Compact Monitor to printer, converter model PI
1115A
4.5.5 Connection to printer
Setting the printing parameters
Refer to the documentation provided with the printer.
4.6 Interfacing computer
A computer is connected to the serial port connector X11 on the frame unit.
Contact your authorized GE Healthcare distributor for further advice on computer interface.
WARNING Always make sure that the combination complies with the international
safety standard IEC 60601-1-1 for medical electrical systems and with the
requirements of local authorities.
WARNING Connecting the power supply cord of the computer to the wall power outlet
may cause the computer leakage current to exceed the limit specified for
medical equipment. A computer must be supplied from an additional
transformer providing at least basic isolation (isolating or separating
transformer).
4.7 Output signals
Analog/ digital output signals on the connectors X4 and X8 can be used for interfacing with
other devices. The pin assignments are illustrated in tables/pictures below.
No parity OFF
Even parity OFF
Serial to Par. OFF
DB9F plugs
into CM1
Centronics
end plugs
into printer
Standard Async Modem Cable
Serial to Parallel
Converter
Standard Parallel Printer
Adapter Cable
Parallel printer
cam p1 inst serial parallel conv p1115A a
PS1002-EU, Power Adapter, 230 VAC Europe,
for PI1115A (included in p/n 78030),
plugs to power supply
p/n 78030 (PI1115A) p/n 713701
p/n 78031
To Next Page
Loading...
