Document no. M1144955-001
AP List
Access Points: shows the access points (max.
eight) which are visible for the monitor.
CH is the WLAN channel configured to this
particular access point.
NL indicates the noise level of the channel used
(0…100%)
SL indicates the signal level of the channel used
(0…100%)
WLAN Config
Network ID is for setting the correct WLAN
network ID name.
WEP Algorithm is for setting the level of the
encryption (width of encryption key) used for
WLAN security (40 bit or 128 bit).
Key ID is for choosing the encryption key used.
Encryption key is for setting the encryption key.
NOTE: When selecting 40 bit encryption, enter 10
Hex digit characters (divided into 2 fields).
When selecting 128 bit encryption, enter 26 Hex
digit characters (divided into 2 fields).
NOTE: Use only hexadecimal characters.
NOTE: For all the monitors and access points in
the same WLAN network, the previous
parameters must be set to be the same.
Channel Mask is for selecting allowed
communication channels, see Appendix C,
Channel Mask Selections in the first manual slot.
To Next Page
Loading...
