GE Feeder Management Relay 750

GE Multilin 750/760 Feeder Management Relay 6-1
6 ACTUAL VALUES 6.1 OVERVIEW
6
6 ACTUAL VALUES 6.1OVERVIEW 6.1.1 ACTUAL VALUES MAIN MENU
Measured values, maintenance, and fault analysis information are accessed in the actual values mode. Actual value mes-
sages are organized into logical groups, or pages, for easy reference as shown in the summary below. All actual value
messages are illustrated and described this chapter.
Actual values may be accessed by any of the following three methods.
1. Front panel, using the keys and display.
2. Front program port, and a portable computer running the 750/760PC software supplied with the relay.
3. Rear RS485/RS422 COM 1 port or RS485 COM 2 port with a SCADA system running user-designed software.
 ACTUAL VALUES
 A1 STATUS
 VIRTUAL INPUTS
 [ENTER] for more
See page 6–5.
 HARDWARE INPUTS
 [ENTER] for more
See page 6–5.
 LAST TRIP DATA
 [ENTER] for more
See page 6–6.
 FAULT LOCATIONS
 [ENTER] for more
See page 6–7.
 CLOCK
 [ENTER] for more
See page 6–7.
 AR
 [ENTER] for more
See page 6–7. (760 only)
 ACTUAL VALUES
 A2 METERING
 CURRENT
 [ENTER] for more
See page 6–9.
 VOLTAGE
 [ENTER] for more
See page 6–10.
 FREQ
 [ENTER] for more
See page 6–11.
 SYNCHRO VOLTAGE
 [ENTER] for more
See page 6–11.
 PWR
 [ENTER] for more
See page 6–11.
 ENERGY
 [ENTER] for more
See page 6–12.
 DMND
 [ENTER] for more
See page 6–13.
 A/I
 [ENTER] for more
See page 6–14.
 ACTUAL VALUES
 A3 MAINTENANCE
 TRIP COUNTERS
 [ENTER] for more
See page 6–15.
 ARCING CURRENT

[ENTER] for more
See page 6–15.
ENTER
ESCAPE
ð
ð
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
ENTER
ESCAPE
ð
ð
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
MESSAGE
ESCAPE
ENTER
ESCAPE
ð
ð
MESSAGE
ESCAPE
Courtesy of NationalSwitchgear.com