GE Multilin 750/760 Feeder Management Relay 1-1
1 GETTING STARTED 1.1 IMPORTANT PROCEDURES
1
1 GETTING STARTED 1.1IMPORTANT PROCEDURES
Please read this chapter to help guide you through the initial setup of your new relay.
1.1.1 CAUTIONS AND WARNINGS
Before attempting to install or use the relay, it is imperative that all WARNINGS and CAU-
TIONS in this manual are reviewed to help prevent personal injury, equipment damage, and/
or downtime.
1.1.2 MANUAL ORGANIZATION
Reading a lengthy instruction manual on a new product is not a task most people enjoy. To speed things up, this introduc-
tory chapter provides a step-by-step tutorial for a simple feeder application. Important wiring considerations and precau-
tions discussed in Chapter 3: Installation should be observed for reliable operation. Detailed information regarding
accuracy, output relay contact ratings, and so forth are detailed in Section 2.2: Specifications. The remainder of this manual
should be read and kept for reference to ensure maximum benefit from the 750 and 760. For further information, please
consult your local sales representative or the factory. Comments about new features or modifications for your specific
requirements are welcome and encouraged.
Setpoints and actual values are indicated as follows in the manual:
A2 METERING ÖØ DMND Ö PHASE A CURRENT Ö LAST PHASE A CURRENT DMND
This “path representation” shows how to navigate menus and sub-menus to get to a specific setpoint or value (in the exam-
ple above,
LAST PHASE A CURRENT DMND). The forward arrows indicate entering a new sub-menu to arrive at a message;
the down arrows indicate scrolling through a sub-menu to arrive at a message. See 1.2.1: Menu Navigation on page 1–2 for
an example of how to navigate setpoints and actual values messages from the relay front panel.
1.1.3 INSPECTION CHECKLIST
• Open the relay packaging and inspect the unit for physical damage.
• View the rear nameplate and verify that the correct model has been ordered.
• Ensure that the following items are included:
• Instruction Manual
• GE Multilin Products CD (includes the 750/760PC software and manuals in PDF format)
• mounting screws
• registration card (attached as the last page of the manual)
• Fill out the registration form and mail it back to GE Multilin (include the serial number located on the rear nameplate).
• For product information, instruction manual updates, and the latest software updates, please visit the GE Multilin web-
site at www.GEindustrial.com/multilin.
If there is any noticeable physical damage, or any of the contents listed are missing, please contact GE
Multilin immediately.
GE MULTILIN CONTACT INFORMATION AND CALL CENTER FOR PRODUCT SUPPORT:
GE Multilin
215 Anderson Avenue
Markham, Ontario
Canada L6E 1B3
TELEPHONE: (905) 294-6222, 1-800-547-8629 (North America only)
FAX: (905) 201-2098
E-MAIL: info.pm@indsys.ge.com
HOME PAGE: http://www.GEindustrial.com/multilin
WARNING CAUTION
NOTE
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
Need help?
General
