GE MEDICAL SYSTEMS - KRETZTECHNIK DRAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-13
8-6-4 EUM - Upgrade Procedure (cont’d)
7.) Click the EUM
button again to install the new EUM.
8.) Select the MO DRIVE
or the DVD/CD DRIVE button, depending on the storage medium you use.
9.) Browse for the EUMSetup_en_V730Pro.exe file again and click OK.
10.)Confirm the following message with YES
to proceed the update.
The contents of this package are being extracted.
11.)Follow the instructions of the “InstallShield Wizard” (confirm the messages with the NEXT
key).
12.)After successfully installation of the Electronic User Manual, click FINISH
to exit the wizard.
13.)Close the
SERVICE page with EXIT and close the “System Setup” with SAVE & EXIT.
14.)Restart the system (turn off and on the system).
15.)After rebooting the system, fill in the requested information into the “System Status Messenger” box
and click OK
.
16.)Press the F1
key on the keyboard to invoke the electronic user manual.
17.)Press the EXIT
key to exit the EUM.
Figure 8-19 Complete Installation
BT Version:
If desired, change the EUM Language as described in Section 3-8-3-3 on page 3-41.
Changing the EUM Language is only possible at systems that were upgraded to BT´05 (SW5.x.x).
To Next Page
Loading...
