GE MEDICAL SYSTEMS - KRETZTECHNIK RAFT VOLUSON® 730PRO / 730PROV (BT´04)
D
IRECTION KTI105947, REVISION 2 SERVICE MANUAL
3-32 Section 3-7 - Printer Installation
3-7-3 Printer Installation manually (cont’d)
13.)Select the manufacturer and model of your printer and confirm with the NEXT
button.
14.)Assign a name, decide if the printer should be used as default printer and confirm with NEXT
.
see: Figure 3-40.
15.)Select ‘Do not share this printer‘ and confirm the “Printer Sharing” window (Figure 3-40) by clicking
NEXT
.
16.)The “Complete the Add Printer Wizard” window appears on the screen.
17.)Complete the manual Printer Installation with the FINISH
button.
18.)Close all open windows, close the “System Setup” with SAVE & EXIT
and restart the system
(turn off and on the system).
Figure 3-40 Assign name and select Printer Sharing - no
Figure 3-41 Complete manual Printer Installation
NOTICE
Ver
After boot up of the system, verify the correct settings in the printer “Properties”, see: Section 3-7-4
"Adjustment of Printer Settings" on page 3-33.
To Next Page
Loading...
