GRAPHTEC FC8000 Series - Setting the Space Rear

4-16
4-17
Setting the Space Rear
Operation
Supplement
SPACE REAR cannot be set if the AP MODE is
off.
1
Turn on the AP MODE by performing the steps 1-6 of "Switching
Apparel Mode"
P.4-14
.
AP MODE is switched on and it will return to AP MODE screen.
2
Press the POSITION (
►
) key (SPACE REAR).
POSITION
SPACE REAR setting screen is displayed.
Supplement
Setting range is between 7 and 30 mm.
3
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
4
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
SEPARATOR settings will be selected and it will return to AP
MODE screen.
Supplement
It will return to
MEDIA setting
screen (2/2)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA setting screen (2/2).
6
Press the [MENU] key.
It will return to default screen.