GRAPHTEC FC8000 Series - Move Away the Tool Carriage

3-4
3-5
Move Away the Tool Carriage
It is possible to move the tool carriage 100 mm toward upper right. It makes it easier to confirm the cutting
results if you perform this operation after the cutting is completed.
Standby position of the pen
carriage
Position of the pen carriage
before moving away
<For rear loading/roll media>
To the bottom of the cutting area
(machine origin point)
<For the sheet>
To the top of
the maximum
cutting area
Bottom of the operation area
Operation
Supplement
Tool carriage will move away to upper right by
continuously performing the same operation.
1
Press the [2] key in READY status.
Tool carriage will move away.
To move the tool carriage to the origin point, do following:
Operation
1
Press the [3] key in READY status.
Tool carriage will move to the origin point.