13-16
13
-
13-17
Creating Test Pattern
Create a self-test pattern to check the operation of the plotter.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will start to move
immediately after selecting to plot the test pattern.
Next page
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Set a media larger than A4 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting the
pen tool.
2
Set the pen tool to the tool carriage and select the condition
where the pen tool is set.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the POSITION (
◄
) key (TEST).
TEST menu screen is displayed.
5
Press the [2] key (SELF TEST).
SELF TEST start screen is displayed.
6
Confirm that the pen tool is set.
CAUTION
Do not place your hand around the moving areas.
The tool carriage will start moving, so there is a
chance of injury.
7
Confirm that operation area of tool and media is safe.
3
To Next Page
Loading...
