GRAPHTEC FC8000 Series - Pouncing (Punch Continuous Holes); Attaching the Pouncing Tool

14-4
14
-
14-5
Pouncing is a method used to create a punched outline on media.
Attaching the Pouncing Tool
Operation
Supplement
See "Attaching a Tool"
P.2-4
for how to
tighten the screws on the tool holder.
1
Loosen the tool holder screw.
CAUTION
Attach the pouncing tool to the half cutting
(backward) side. It may damage the panel if it is
attached to the forward side.
For half cutting
(backward)
For cutting out
(forward)
Supplement
See "2 Pen Assignment (Switching the Tools)"
P.14-7
for 2-pen option.
2
While pushing the tool holder in the upward direction, push the
pouncing tool all the way into the holder until its flange contacts
the upper part of the holder. The flat edge must be parallel to
the tool holder.
Flat edge
Upper part of
tool holder
In
parallel
Flange
3
Make sure that the tool bracket is engaged mounted firmly over
the flange, and then tighten the screw.
Flange
Bracket to hold tool
2
Pouncing (Punch Continuous Holes)