GRAPHTEC FC8000 Series - Detect the Registration Mark for Adjustment on the Media and Enter the Value

5-26
5-27
Detect the Registration Mark for Adjustment on the Media and Enter the
Value
Method to enter the adjustment value, which is the difference between the scanned registration mark on the
media and the cutting position, is described here.
Supplement
Plot the registration mark before going to following steps if there is no registration mark written on the media. See "Adjust After Plotting the
Adjustment Registration Mark"
P.5-24
to plot registration marks.
Next page
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Load the media with adjustment registration mark in the plotter.
2
Press the [MENU] key.
MENU screen is displayed.
3
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
4
Press the POSITION (
▼
) key twice.
POSITION
ARMS SETTING screen (3/4) is displayed.
Supplement
It will return to ARMS setting screen (3/4) without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
5
Press the [1] key (SENSOR OFFSET ADJ.).
SENSOR OFFSET ADJ. setting screen is displayed.