GRAPHTEC FC8000 Series - Page 127

5-26
5-27
Supplement
Position of the registration mark is measured at
the center of the line.
11
Using the registration mark plotted in step 9, measure the
distance of how much the comparison registration mark needs
to be moved so both will overlap, and record the value. As
an example, in the figure above, it needs to move in negative
directions for both X and Y directions, so both of the adjustment
values will be negative values.
12
Press the [3] key (X).
SENSOR OFFSET ADJ. X screen is displayed.
13
Press the POSITION (
▲▼
) key and increase or decrease the
setting value. Set the X value measured in step 11.
POSITION
14
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
SENSOR OFFSET ADJ. is selected and it will return to SENSOR
OFFSET ADJ. screen.
15
Press the [4] key (Y).
SENSOR OFFSET ADJ. Y screen is displayed.
16
Press the POSITION (
▲▼
) key and increase or decrease the
setting value. Set the Y value measured in step 11.
POSITION
17
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
SENSOR OFFSET is selected and it will return to SENSOR
OFFSET ADJ. screen.
Supplement
It will return to ARMS setting screen (3/4)
without changing the setting when you press the
POSITION (
◄
) key (CANCEL).
18
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS setting screen (3/4).
19
Press the [MENU] key.
It will return to the default screen.