4-8
4
-
4-9
Copy (Duplicate Cutting)
The function to cut specified numbers of cutting data stored in the buffer memory is called COPY.
Supplement
Do not send new data to plotter while copying. Cutting data in the buffer memory will be cleared.
Previous cutting data will be cleared and newly sent data will be stored as cutting data if you send new data with 10 seconds or more interval
from the time it finished cutting.
It can not copy if data is more than 1.6 MB because it cannot be stored in the buffer memory of the plotter.
Buffer memory that can be used for copy will decrease if you turn on the data sort. Turn off the data sort when you need to copy cutting with
large data. See "Sorting the Cutting Data"
P.8-2
for data sort.
Watch out that it does not fall out of media when cutting with copy function.
If the original cutting data to be copied starts away from the origin point, copied cutting will also start away from the origin point. To avoid
wasted space, create the cutting data close to the origin point.
l
l
l
l
l
l
Copy is performed in following order.
Supplement
For the front loading model, rotate the above
figure 180 degrees.
<For rear loading/sheet>
Second copy Fourth copy
First copy Third copy
Origin point
Copy origin
point
Copy
space
Copy space
First cut
It will copy in following order when MIRROR is set.
Supplement
For the front loading model, rotate the above
figure 180 degrees.
First cut
<For rear loading/sheet>
Copy origin point
Origin point
First copy Third copy
Copy
space
Copy space
Second copy Fourth copy
2
To Next Page
Loading...
