GRAPHTEC FC8000 Series - Setting the Speed

2-28
2-29
8
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
9
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
10
Press the [CONDITION] key.
It will return to default screen.
Setting the Speed
Set the speed of the tool that is used in each of the condition numbers. (Setting range: 1 to 10 (in 1 cm/s
increment), 10 to 105 (in 5 cm/s increment))
Operation
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen (1/3) without
changing the settings when you press the [4] key
(CANCEL).
2
Press the [3] key (SPEED).
SPEED setting screen is displayed.
* Display may vary depending on the selected tool condition number.
3
Press the POSITION (
◄►
) key and select the tool condition
number (CONDITION No.).
POSITION
Supplement
Guideline to set speed
See "Setting the Tool Condition"
P.2-24
.
4
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
6
Press the [CONDITION] key.
It will return to the default screen.