GRAPHTEC FC8000 Series - Page 54

2-26
2-27
Next page
3
Press the [1] key.
CONDITION No. selection screen is displayed.
* Display may vary depending on the selected condition number.
4
Press the POSITION (
▲▼
) key and select the condition number
(CONDITION No.).
POSITION
5
Confirm the setting and press the POSITION (
◄
) key
(PREVIOUS).
POSITION
CONDITION No. will get set and return to TOOL setting screen.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (
◄
) key (CANCEL).
Tools that can be selected are as following:
CB09U, CB15U-K20-SP, CB15U, CB15UB,
CB15U-K30, OTHER, POUNCE, LIGHT
POINTER, PEN
l
l
6
Press the POSITION (
▲▼
) key, and set the tool.
POSITION
Supplement
What is Offset
It will adjust the difference between the tip of the
blade in the plunger and the center of the plunger.
There are standard adjustment values for each
cutter blades. Fine adjustment will be made to that
standard values here. (Adjustment will be made
with standard value as 0.)
It is not necessary to set the offset if "Pen",
"Pouncing", or "Light Pointer" was selected in the
tool settings.
Guideline to Set Offset
Blade
material/
tool
Blade type Setting
range
Setting
value for
OTHER
Ultra-hard
blade
CB09U ± 5 18
CB15U-K20-SP ± 5 28
CB15U ± 5 28
CB15UB ± 5 5
CB15U-K30 ± 5 28
Other*
―
1
~
45 1
* Set for the setting values not displayed in the
cutter blade type when cutting the media that is
hard to cut.
Guideline to Set Pouncing
Blade
material/tool
Setting range
(intervals)
Setting
value for
OTHER
Pouncing 1
~
99 1
To return to continue the settings of other tool
condition number, return to step 3 by pressing
the [1] key.
l
l
l
l
7
Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
* Display may vary depending on the selected condition number.