GRAPHTEC FC8000 Series - Confirm the Cutting Data

13-18
13
-
13-19
Confirm the Cutting Data
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the
transmission of cutting data is performed correctly.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will start to move
immediately after selecting to print the dump list.
Supplement
There may be a difference in the RS-232C transmission condition or the command setting when the printed output and the display of
transmission data does not match. Check the transmission condition and the command.
Next page
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Set a media larger than A4 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting the
pen tool.
2
Set the pen tool to the tool carriage and select the condition
where the pen tool is set.
3
Press the [MENU] key.
MENU screen is displayed.
4
Press the POSITION (
◄
) key (TEST).
POSITION
TEST menu screen is displayed.
5
Press the [3] key (START DATA DUMP).
DATA DUMP start screen is displayed.
4