GRAPHTEC FC8000 Series - Related to GP-GL Command; Setting the Step Size (STEP SIZE)

11-4
11-5
Related to GP-GL Command
This can be changed only when the GP-GL command is enabled in the COMMAND.
Setting the Step Size (STEP SIZE)
The distance to travel with 1 step can be changed. Match the setting value of the application to be used.
Operation
1
Press the [MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION (
▲
) key (I/F).
POSITION
INTERFACE setting screen (1/3) is displayed.
3
Press the [4] key (STEP SIZE).
GP-GL STEP SIZE setting screen is displayed.
4
Press the [1] key (0.100 mm), the [2] key (0.050 mm), the [3]
key (0.025 mm), or the [4] key (0.010 mm).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACE setting screen (1/3).
6
Press the [MENU] key.
It will return to the default screen.