GRAPHTEC FC8000 Series - Assigning Tool Number

14-8
14-9
Assigning Tool Number
Supplement
This setting is maintained even if the power is
turned off.
Physical pen 2 can be set only when the tool is
mounted on the pen station on the 2-pen plotter.
See "Attaching to Tool Holder (Option)"
P.14-7
and "Attaching to the Pen Station"
P.14-8
for mounting of the tools.
l
l
l
The tool number to use can be set for each of the 8 TOOL
CONDITION No.
Tool 1
will use the tool attached to the backward
of the tool holder
(for half cutting)
,
tool 2
will use the tool attached
to the pen station, and
tool 3
will use the tool attached to the
forward of the tool holder
(for cutting out)
.
Next page
Operation
CAUTION
Only the plotting pens can be mounted on the pen
station. Do not mount the cutter pens.
1
Press the [CONDITION] key.
CONDITION setting screen (1/3) is displayed.
2
Press the POSITION (
▼
) key.
CONDITION setting screen (2/3) is displayed.
3
Press the [3] key (ASSIGN TOOL).
ASSIGN TOOL setting screen is displayed.
4
Press the POSITION (
◄►
) key and select the CONDITION No.
POSITION
Supplement
Tool number [2] can be set only when the tool is
mounted on the pen station on the 2-pen plotter.
Only [1] can be set when using the pouncing
tool.
l
l
5
Press the [1], the [2], or the [3] key and select the tool number
to set.
Supplement
It will return to CONDITION screen (2/3) without
changing the settings when you press the [4] key
(CANCEL).
6
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (2/3).