GRAPHTEC FC8000 Series - 7-5 Setting Cut Line Pattern

7-14
7
-
7-15
Lines can be cut with perforated lines so the cut parts will not fall off. There are 8 different patterns of
perforated lines set as 0 to 7, and the ratio of cut and uncut part differs in each (tool is raised or the force is
decreased for following length every 8 mm of the cut). The uncut part becomes shorter with smaller value,
making it easier to separate the cut parts.
l
Pattern 0: 0.15 mm
l
Pattern 1: 0.20 mm
l
Pattern 2: 0.25 mm
l
Pattern 3: 0.30 mm
l
Pattern 4: 0.35 mm
l
Pattern 5: 0.40 mm
l
Pattern 6: 0.45 mm
l
Pattern 7: 0.50 mm
In addition to above 8 patterns, there are "OFF", which cuts with solid line, and "USER", where user can
specify an unique pattern. Processing of the uncut part of the perforated lines are set with settings in" UP
MODE". CUT LINE PATTERN can be specified for each CONDITION No.
Supplement
Normally use it with default value OFF. It will cut with solid line.
Use TOOL3 for the cut with perforated lines (other than OFF).
Do not use TOOL1 for the cutting out with perforated lines, instead of normal film cut (half cutting), because it will affect normal cutting by
making scratches on the cutting mat.
Replacement of the cutting mat will be with charge if it is damaged by performing perforated cut using the TOOL1.
l
l
l
l
Next page
Operation
1
Press the [CONDITION] key.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to default screen without changing the
settings when you press the [CONDITION] key.
2
Press the POSITION (
▼
) key.
POSITION
CONDITION screen (2/3) is displayed.
3
Press the [2] key (CUT LINE PATTERN).
CUT LINE PATTERN setting screen is displayed.
Setting Cut Line Pattern
5