GRAPHTEC FC8000 Series - Setting the Tool Number

2-32
2-33
Setting the Tool Number
Set the tool that is used in each of the tool condition numbers. (Setting range: 1 to 3)
Next page
Operation
1
Press the [CONDITION] key in the default screen.
CONDITION setting screen (1/3) is displayed.
2
Press the POSITION (
▼
) key.
POSITION
CONDITION setting screen (2/3) is displayed.
Supplement
It will return to CONDITION screen (2/3) without
changing the settings when you press the [4] key
(CANCEL).
3
Press the [3] key (ASSIGN TOOL).
ASSIGN TOOL setting screen is displayed.
* Display may vary depending on the mounted tool.
Supplement
Tool number and attached position
For half cutting (backward)
For cutting out (forward)
TOOL 1: When using the tool attached in
backward position of the tool folder
TOOL 2: When using the tool attached on the tool
station with the 2 pen option
TOOL 3: When using the tool attached in forward
position of the tool holder
Attaching methods of the tool
See "Attaching a Tool"
P.2-4
and "2-Pen
Assignment (Switching the Tools)"
P.14-7
.
l
l
4
Press the POSITION (
◄►
) key and select the tool condition
number (CONDITION No.).
POSITION