GRAPHTEC FC8000 Series - Setting the Tool up Speed

8-8
8
-
8-9
TOOL UP SPEED is the speed the tool moves when it is raised.
The cutting time in total becomes short if you set the TOOL UP SPEED to fast speed even though the speed
of the tool when it is cutting (lowered) is set to slow speed for the hard to cut media (hard or sticky).
Supplement
Setting for the TOOL UP SPEED is maintained even if the power is turned off.
Next page
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
3
Press the POSITION (
▼
) key.
POSITION
TOOLS SETTING screen (2/3) is displayed.
4
Press the [3] key (TOOL UP SPEED).
TOOL UP SPEED setting screen is displayed.
Setting the Tool Up Speed
5