GRAPHTEC FC8000 Series - 12-2 Replacing Cutter Blade

12-2
12
-
12-3
2
Replacing Cutter Blade
Supplement
See "Structure of Cutter Pen"
P.2-2
for the
structure of the cutter pen.
Replace the cutter blade by referring to the structure diagram of
the cutter pen.
Operation
1
Turn the blade-length adjustment knob in the direction indicated
by the arrow to retract the blade into the plunger.
One scale unit
approximately 0.1 mm
2
Turn the plunger cap in the counter-clockwise direction to
remove it from the plunger.
3
Remove the blade from inside the plunger cap.
4
Remove a new blade from its pack. Insert the new blade into the
hole provided in the plunger cap.
5
With the blade inserted into the plunger cap, screw on the
plunger from above.