1-4
1-5
Rear View
Push roller hold-down force switching lever
Media set lever
Stock rollers
Media stocker
AC line inlet
USB interface
Media lock
RS-232C interface
Network interface (Factory-installed option)
Media set lever ...................... Used to raise or lower the Push rollers during the loading or unloading of media.
Push roller hold-down force switching lever
.............................................. Used to switch between the three push roller forces (outside push rollers only has
2 forces of strong and medium).
AC line inlet ........................... Inlet where the power cord is connected.
Media stocker ........................ Used to carry roll media and ensure its proper rotation.
Stock rollers ........................... A media roll is placed on these rollers.
Media lock ............................. Used to prevent the stock rollers from rotating when the media roll has been
placed on top of them. The media lock ensures that the media is pulled straight
out from the roll.
USB interface connector ....... Used to connect the plotter to the computer with a USB interface cable.
Network interface connector
.... Used to connect the plotter to the computer with a network interface cable.
(Factory-installed option)
RS-232C interface connector
.............................................. Used to connect the plotter to the computer with a RS-232C interface cable.
To Next Page
Loading...
