GRAPHTEC FC8000 Series - Running Cutting Tests; Cutting Test; To Make 1 Cut with Set Value

2-34
2
-
2-35
Running Cutting Tests
Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that
the selected cutting conditions actually produce the desired cutting results. Check how far the blade cuts
into the media and how the corners are being cut. If the cutting results are not satisfactory, adjust the
various settings and repeat the test cutting until the optimal settings are achieved.
Cutting Test
Perform the cutting test by deciding to make 1 cut with set value only, or to make 3 cuts with set value and ±1
of set value, depending on the condition.
To make 1 cut with set value
Operation
1
Load the media for test cutting in the plotter.
2
Press the [CONDITION] key in the default screen.
CONDITION screen (1/3) is displayed.
Supplement
It will return to CONDITION screen (1/3) by
pressing the [4] key (CANCEL).
3
Press the POSITION (
◄
) key (CUT TEST).
4
Press the POSITION (
▲▼◄►
) key the tool carriage to the
location you wish to perform the test cutting.
POSITION
CAUTION
When the [ENTER] key is pressed, the tool
carriage will start moving, so take care not to cut
your fingers.
5
Press the [ENTER] key.
1 cut test pattern is cut.
6
Press the [ENTER] key after completion.
CONDITION screen (1/3) is displayed.
7
Press the [CONDITION] key.
It will return to the default screen.
10