5-33
5
Press the [2] key (ARMS).
ARMS SETTING screen is displayed.
6
Steps are different from here depending if it is going to move to
registration mark automatically to scan the registration mark, or
if it is going to move manually to scan. See next section.
P.5-34
Automatically Adjust
P.5-36
Adjust Manually
Adjust with 4POINTS
4POINTS adjustment will scan 4 registration marks in the corners, where the adjustment is done measuring the
tilting of the X and Y axes and the distance between each of the registration marks. It will perform 2 axes warp
adjustment in addition to the 2 axes (tilt) adjustment and distance adjustment, so it can adjust more precisely
than other methods.
Print Cut
Image is printed tilted
and warped
GRAPHTEC 2POINT adjusted cut
General 1POINT adjusted cut
Data
Next page
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1
Load the media with registration marks (4POINTS) plotted.
2
Set the MARK SCAN MODE to ARMS, and POINTS to
2POINTS.
P.5-6
Setting MARK SCAN Mode and Numbers
To Next Page
Loading...
