GRAPHTEC FC8000 Series - 14-2 Pouncing (Punch Continuous Holes)

14-6
14
-
14-7
2-Pen Assignment (Switching the
Tools)
3
Attaching to Tool Holder
The 2-pen unit is a factory-installed option. It cannot be retrofitted.
Next page
Operation
Supplement
See "Attaching a Tool"
P.2-4
for how to
tighten the screws on the tool holder.
1
Loosen the tool holder screw.
CAUTION
When pushing the tool holder with your fingers,
the blade tip may be protruding. Take care not to
cut your fingers.
Supplement
The forward position of the tool is used for the
cutting out mainly, and the backward position is
used for the half cutting mainly.
Cutting out means that the media is cut out
completely.
Half cutting means that only the marking film is
cut out, leaving the backing sheet uncut.
See "What is Cutting Plotter?" in Setup Manual
for structure of the marking film.
l
l
l
l
2
While pushing the tool holder in the upward direction, push the
tool all the way into the holder until its flange contacts the upper
part of the holder.
Flange
Upper part of
tool holder
For half cutting
(backward)
For cutting out
(forward)