3-14 3-15
Cross Cut Manually
Media is cross cut at the position 15 mm behind the last cut position.
If the cutting was very small, cross cut will be made at 40 mm including the cutting itself.
15 mm
Min. 40 mm
Feed direction of media
It is possible to cut off the roll media at desired position by cross cutting after manually moving the media using
the POSITION (
▲▼
) key.
CAUTION
Do not place your hand where the blade might move. You may be injured.
1
Press the [CROSS CUT] key in the READY status.
CROSS CUT screen is displayed.
Supplement
It will return to default screen without cross cut by
pressing the [2] key (CANCEL).
2
Press the [1] key (CUT).
Media is cross cut.
To Next Page
Loading...
